Leon Mk1
Cylinder head - Assembly overview |
1 - | Cylinder head gasket |
q | replace → Chapter „Removing and installing cylinder head“ |
q | Fitting position: the part number points toward the cylinder head |
q | If replaced, new coolant must be used. |
2 - | Cylinder head |
q | Removing and installing → Chapter |
q | Checking for distortion → Fig. |
q | Reworking dimensions → Fig. |
q | If replaced, new coolant must be used. |
3 - | Oil deflector |
q | Note fitting position: |
4 - | Cylinder head bolt |
q | replace |
q | Sequence when loosening → Anchor. |
q | Note correct sequence when tightening → Anchor |
5 - | Cylinder head cover: |
q | Removing and installing → Chapter |
6 - | Ignition coil |
7 - | Sealing cap |
8 - | Seal |
q | Replace if damaged or leaking. |
9 - | 10 Nm |
q | First tighten inner nuts |
q | Tighten outer nuts diagonally |
10 - | Gaskets for cylinder head cover |
q | Replace if damaged or leaking. |
q | Before fitting, apply sealant at sealing points → Fig. and → Fig. |
11 - | Seal |
q | replace |
12 - | Combination valve secondary air |
q | With connecting pipe |
q | Removing and installing → Chapter |
13 - | 10 Nm |
14 - | Coolant flange |
q | With coolant temperature sender |
15 - | 10 Nm |
16 - | O ring |
q | replace |
|
|
|
|