seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fuel supply, gas operation > < Parts of cooling system (on body)

Leon Mk1

Removing and installing toothed belt for coolant pump
Removing and installing toothed belt for coolant pump
Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter
Special tools and workshop equipment required
   
t  Spanner -T10360-, see equivalent → Anchor
  W00-10515
t  Torque wrench -VAG 1331-, see equivalent → Anchor.
Removal:
–  Remove small coolant pipe → Chapter.
  W00-0427
–  Remove the coolant hoses -1 and 2- and move clear to one side.
  A19-10718
–  Remove bolts -arrows- and detach toothed belt cover.
  Caution
Risk of damage to thread.
The drive sprocket bolt has a left-hand thread.
  A19-10460
–  Unscrew the drive sprocket bolt -1- from the coolant pump with the torque wrench -VAG 1331- and with the tool -T10360-, by locking the vibration damper..
–  Detach drive sprocket -1- and toothed belt -2-.
Installation
l  Tightening torque → Chapter
Installation is carried out in the reverse sequence; note the following:
  Note
t  Replace the drive sprocket bolt.
t  Replace gaskets and O-rings.
t  Observe the installation position of the sprocket for the toothed belt → Item.
–  Install small coolant pipe → Chapter.
–  Fill up with coolant → Anchor.
  A19-10461

Fuel supply, gas operation > < Parts of cooling system (on body)