SEAT Workshop Service and Repair Manuals

Removing and installing fuel filter t  Removing → Anchor t  Install → Anchor. t  Tightening torques → Anchor Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter Special tools and workshop equipment required

t  Collecting tray -VAS 6208-, see equivalent → Anchor Removing –  Observe all safety precautions and rules for cleanliness → Chapter.

–  Remove the right hand cover -1- on the fuel tank. –  Place the drip tray -VAS 6208- under the fuel filter.   WARNING The fuel system is pressurised. Before opening the system place a cloth around the connection. Then release pressure by carefully loosening the connection.

–  Remove the fuel supply line -1-, -2- and -4-. Press the unlocking button. –  Remove bolt -3-. –  Take fuel filter off. Installing Installation is carried out in the reverse sequence; note the following:

Fitting position: Direction of flow is indicated with an arrow on filter housing. The arrow marks -1- and -2- must be opposed to each other.

Distance between fuel return line and fuel tank: FWD: -a- = 6 … 10 mm. Four-wheel drive: -a- = 3 … 7 mm. Tightening torques

Component	Nm
Retaining clamp for fuel filter	1,2