Leon Mk1
Assembly overview |
1 - | Electrical connector |
2 - | Oil pressure switch -F1-, 25 Nm |
q | check → Chapter |
q | In case of leakage, cut out and replace sealing ring |
3 - | 20 Nm |
4 - | Oil filler cap |
5 - | Oil dipstick |
q | Oil level must not be above max. mark on dipstick! |
q | Marks → Fig. |
6 - | Filling funnel |
q | Remove and evacuate the oil by absorption |
7 - | Guide pipe |
8 - | Principal notched belt: |
q | Mark direction of rotation before removing |
q | Check for wear |
q | Do not kink |
q | Notched belt routing → Fig. |
q | removing, installing and tensioning → Chapter |
9 - | Idler wheel |
q | For the main timing belt |
10 - | Oil filter |
q | Loosen using an hexagon |
q | Tighten by hand |
q | Observe the installation instructions printed on the filter |
11 - | Oil pump: |
q | Always replace completely |
q | When fitting, remember the crankshaft traction element → Item |
q | Must sit on dowel sleeves |
q | removing and installing → Chapter |
12 - | 12 Nm |
q | Replace. |
13 - | Crankshaft sprocket |
14 - | Seal |
q | Renew → Chapter |
15 - | Gasket |
q | Replace. |
16 - | 20 Nm |
17 - | Gasket |
q | Must sit on dowel sleeves |
q | Replace. |
18 - | 10 Nm |
19 - | Oil intake pipe |
q | Clean strainer if dirty |
20 - | Principal belt tension roller |
q | check → Chapter |
q | Tension the notched belt. → Chapter |
21 - | Oil level/oil temperature sender -G266- |
q | Depending on version |
22 - | Seal |
q | Replace. |
23 - | Oil sump |
q | Clean sealing surface before installing |
q | Fit using sealant -D 176 404 A2- |
q | removing and installing → Chapter |
24 - | Oil drain plug, 30 Nm |
q | With safety washer |
q | Replace. |
25 - | Attachment bolts, 13 Nm |
q | Loosen and fasten the bolts on the side of the flywheel using the socket -T10058-. |
26 - | 45 Nm |
27 - | Coupling |
q | Oil well before fitting the oil pump |
28 - | Seal |
q | Replace. |
29 - | Oil settling tank |
q | With heated vacuum valve |
30 - | O-ring |
q | Replace if damaged |
31 - | Leads to intake manifold |
q | To the engine block ventilation preheating → Item |