SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4 cylinder Fuel-injection engine (1.4l, 4 valves) | Fuel supply, gas operation | Electronic regulation of engine output, electronic accelerator

Accelerator pedal module: removing and fitting

Special tools and workshop equipment required

t	Hose clamp -T10238-, see equivalent → Anchor

Removal:

–	Remove the instrument panel and pedal cover.

–	Remove the accelerator pedal module from the fitting.

–	Remove the protective cap of the upper section of the accelerator pedal module.

–	Remove the securing bolt.

–	To remove the accelerator pedal module, insert the release tool -T10238- or -T10240- (for right-hand drive vehicles) to the limit in the holes has shown.

–	Remove the accelerator pedal module by pulling upwards.

Fitting .

Installation is carried out in reverse order.

Tightening torque of fastening bolts: 10 Nm

SEAT Workshop Service and Repair Manuals