seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Crankshaft > < Subframe

Leon Mk1

Removing and installing poly V-belt
Removing and installing poly V-belt
removing → Anchor
Fitting → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Interlocking mandril -T10060A-, see equivalent → Anchor
removing
–  Remove the central soundproofing pan → Bodywork, exterior fitting work; Rep. Gr.50.
–  Mark direction of rotation of ribbed belt.
  W00-10235
–  Turn tensioning device in direction of arrow to relieve tension on Poly-V belt.
  A13-0083
–  Lock the tensioning device with the pin -T10060A-.
–  Remove Poly-V belt.
Fitting
–  Installation is carried out in the reverse sequence; note the following:
  Note
t  When fitting the ribbed belt, ensure that it is fitted with the correct direction of rotation and that it is correctly seated on the pulleys.
t  For those vehicles not fitted with air conditioning, fit the Poly-V belt lastly on the alternator.
t  For those vehicles fitted with air conditioning, fit the ribbed belt lastly on the compressor for the air conditioning.
When finishing the work, always:
–  Start engine and check belt running.
  N13-10135
Belt routing without air conditioning compressor
  N13-0755
Belt routing with air conditioning
  N13-0754

Crankshaft > < Subframe