Leon Mk1
Rear sealing flange and dual-mass flywheel - exploded view |
Note
Servicing clutch: → Rep. gr.30 |
1 - | Bolt. |
q | For the dual-mass flywheel/ drive plate |
q | 60 + 90° (1/4 turn) |
q | Replace |
2 - | Dual-mass flywheel |
q | Removing and installing dual-mass flywheel → Chapter. |
q | Can only be installed in one position (out of step bolts) |
3 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage or bend when assembling. |
q | Is suspended on the gasket → Fig. |
4 - | Bolt. |
q | Tightening sequence → Fig. |
5 - | Remove and fit the crankshaft sealing flange (flywheel side) |
q | Only replace complete |
q | To fit, use the guide sleeve provided |
q | Removing and installing → Chapter |
q | Do not grease or oil the seal lip of the seal |
q | Before fitting, use clean cloth to wipe off oil residue at crankshaft journal. |
q | The guide sleeve should only be removed after fixing the sealing flange on the crankshaft journal |
6 - | Dowel pin |
7 - | Bolt. |
q | Tightening sequence → Fig. |
8 - | cylinder block |
q | Removing and installing crankshaft → Chapter. |
q | Dismantling and assembling pistons and conrods → Chapter |
|
|