SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Remove and install the bottom cover of the timing chain >
< Removing and installing camshaft control valve?1N205
Leon Mk1
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Engine cylinder head, valve gear
Chain drive
Removing and installing timing chain cover (top)
Removing and installing timing chain cover (top)
Removing and installing timing chain cover (top)
Removing
→ Anchor
.
Installing
→ Anchor
.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Torque wrench 2 - 10 Nm -VAG 1783-, see equivalent
→ Anchor
Removing
–
Remove the purging line
-1-
, disengage the activated carbon vessel
-A-
and remove upwards
-B-
. Move the activated carbon vessel to one side.
–
Push coolant hoses to one side and secure with cable ties.
–
Detach the connector for valve 1 of the variable valve timing -N205-
-1-
–
Unscrew bolts
-arrows-
and remove camshaft control valve 1 -N205-.
–
Unscrew bolts
-1 to 5-
and remove timing chain cover (top).
Fitting
Installation is carried out in the reverse order, noting the following:
–
Oil the seal and the O-ring with engine oil.
–
Tighten the bolts
-1 to 5-
by hand in the sequence specified:
–
Tighten the bolts to a torque of 9 Nm using the torque wrench socket 2 - 10 Nm -VAG 1783- and the 10 mm socket -V.A.G 1783/1-.
–
Install camshaft control valve 1 -N205-
→ Chapter
.
l
Tightening torque
→ Chapter
Power unit
4 cylinder Injected engine (engine 1.8 l and 2.0 l, timing chain)
Engine cylinder head, valve gear
Chain drive
Removing and installing timing chain cover (top)
Remove and install the bottom cover of the timing chain >
< Removing and installing camshaft control valve?1N205