Release tool -T10240-, (right-hand drive vehicles) see equivalent → Anchor
Removing
–
Remove the pedal assembly cover:
–
Unplug connector from the accelerator pedal module.
–
Remove the protective cap of the upper section of the accelerator pedal module.
–
Remove the securing bolt.
–
To remove the accelerator pedal module, insert the release tool -T10238- or release tool -T10240- (for vehicles with the steering wheel on the right hand side) to the limit in the holes as shown.
–
Remove the accelerator pedal module by pulling straight upwards.
Installing
Installation is carried out in the reverse sequence; note the following: