Leon Mk1
Ignition system - exploded view |
1 - | Connector |
q | 4-pin, black |
q | Remove with extractor -T10118- |
2 - | Ignition coil 3 with output stage -N291- |
q | Ignition coil 1 with output stage -N70- |
q | Ignition coil 2 with output stage -N127- |
q | Ignition coil 4 with output stage -N292- |
q | removing and fitting → Chapter |
3 - | Connector |
q | Black, 2-pin |
q | For knock sensor 1 -G61-. |
q | Connector contacts are gold-plated |
4 - | Knock sensor 1 -G61- |
q | Connector contacts are gold-plated |
5 - | 20 Nm |
q | Tightening torque affects the knock sensor function |
6 - | Connector |
q | 3-pin, black |
q | for Hall sender -G40- |
7 - | Hall sender -G40- |
8 - | O ring |
q | Replace if damaged |
9 - | 10 Nm |
10 - | Spark plug, 30 Nm |
q | Remove and install with spanner -3122B- |
q | Type and electrode gap → Chapter. |
11 - | Cable duct |
q | Tighten the camshaft housing to a torque of 5 Nm |
12 - | Negative wire |
q | Loosen or tighten only with ignition switched off. |
13 - | 10 Nm |
q | Loosen or tighten only with ignition switched off. |