Leon Mk1
| Crankshaft: removing and fitting |
| 1 - | Semi bearings 1, 2, 4 and 5 |
| q | For bearing caps 1, 2 and 5 without lubrication groove |
| q | For bearing cap 4 and engine block with oil groove |
| q | Do not mix up used bearing shells (mark them) |
| 2 - | 65 Nm + 1/4 turn (90°) |
| 3 - | Bearing caps |
| q | Bearing cap “1”: Distribution side |
| q | Bearing cap “3” with recesses for thrust washers |
| Bearing shell retaining lugs (cylinder block/bearing cap) must be on the same side. |
| 4 - | Semi bearing 3 |
| q | For bearing cap without oil groove |
| q | For cylinder block with oil groove |
| 5 - | Thrust washer |
| q | For bearing cap “3” |
| q | Note fixing arrangement |
| 6 - | Generator wheel |
| q | Except for identification letters 1F |
| 7 - | 10 Nm + 1/4 turn (90°) |
| q | Except for identification letters 1F |
| q | Replacement |
| 8 - | Crankshaft |
| q | Axial clearance: |
| New: 0.07…0.17 mm |
| Wear limit: 0.25 mm |
| q | Check radial clearance with Plastigage |
| New: 0.02…0.06 mm |
| Wear limit: 0.17 mm |
| Do not rotate the crankshaft when checking the radial clearance |
| q | Crankshaft dimensions → Chapter |
| 9 - | Thrust washer |
| q | For cylinder block, bearing 3 |
