Pressing sealing flange with sender wheel onto crankshaft |
Note t
| The sealing flange with the PTFE seal is fitted with a pressure ring on the sealing lip. This support ring acts as an assembly sleeve and must not be removed before installation. |
t
| Sealing flange and sender wheel must not be separated or rotated out of position after removal from packaging. |
t
| The sender wheel is held in its installation position on the assembly device -T10134- by a locating pin. |
t
| Sealing flange and oil seal form one unit and must only be renewed together with the sender wheel. |
t
| The assembly device -T10134- is held in its position relative to the crankshaft by a guide pin inserted into a hole in the crankshaft. |
|
|
|