Leon Mk1
Assembly overview - supercharger |
1 - | Housing with noise insulation |
q | For noise insulation. |
2 - | Noise insulation |
q | For intake air. |
3 - | Suction line |
q | Immobilise with spring clips |
4 - | 7 Nm |
q | Self-tapping bolt. |
q | The securing screws should only be tightened with a screwdriver when their max torque is set to 500 / min and a tightening torque of maximum 7 Nm. |
5 - | 7 Nm |
6 - | 7 Nm |
q | Self-tapping bolt. |
q | The securing screws should only be tightened with a screwdriver when their max torque is set to 500 / min and a tightening torque of maximum 7 Nm. |
7 - | O ring |
q | Replace |
8 - | Pressure pipe |
9 - | Noise insulation |
10 - | Housing |
q | For noise insulation. |
11 - | Noise insulation |
q | For charge air. |
q | With shaft seal |
q | Renew seal between supercharger and noise insulation. |
12 - | Pulley |
q | For supercharger. |
13 - | 8 Nm |
14 - | Coolant pump with magnetic clutch for supercharger -N421- |
15 - | Poly-V belt |
q | For supercharger. |
Caution
|
16 - | 23 Nm |
17 - | Tensioner |
q | For supercharger poly V-belt. |
q | Relieve tension using 16 mm open-end spanner -T10241-. |
q | Lock with locking pin -T10060 A-. |
18 - | 40 Nm +1/4 turn further (90º) |
q | To loosen and tighten securing bolt, counterhold supercharger shaft with spanner. |
q | Replace |
19 - | Supercharger |
q | Removing and installing → Chapter. |
20 - | 25 Nm |