seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Turbocharger - exploded view > < Supercharger

Leon Mk1

Turbocharger
Turbocharger
  Note
t  Secure all hose connections with hose clips which conform to production standard.
t  Hose connections and hoses for charge air system must be free from oil and grease before fitting. However (applies only to plug-in connectors); the seal and the sealing surface of plug-in connectors should be lubricated lightly with oil → Chapter.
t  The supercharger air system should not leak
t  Renew self-locking nuts.
   
t  Spring-type clip pliers -VAS 5024A- or hose clip pliers -VAS 6340- are recommended for installation of spring-type clips.
t  Fill turbocharger with engine oil at oil supply line connection.
t  After installing turbocharger, run engine for about 1 minute at idle and do not rev up immediately. This ensures that the turbocharger is fully primed with oil.
Assembly overview - turbocharger → Chapter.
Removing and installing turbocharger → Chapter.
Checking turbocharger vacuum unit → Chapter.
Removing and installing vacuum unit for turbocharger → Chapter.
Adjusting vacuum unit for turbocharger → Chapter.
  W00-10380

Turbocharger - exploded view > < Supercharger