When working on the fuel supply and injection system, pay careful attention to the following „5 rules“ for cleanliness: |
t
| Thoroughly clean all joints and connections and the surrounding areas before dismantling. |
t
| Place removed parts on a clean surface and cover. Use only lint-free cloths. |
t
| If repairs cannot be carried out immediately, carefully cover or seal open components. |
t
| Install only clean parts: only remove replacement parts from packaging immediately prior to installation. Do not use any parts which have not been stored in their packaging (e.g. in a tool box). |
t
| If the system is open: do not work with compressed air if this can be avoided. Do not move vehicle unless absolutely necessary. |
|
|
|