–
| Screw out the lambda probe -arrow- with the wrench kit -3337-. |
Note The engine is shown removed in the figure. |
Installation is carried out in the reverse order of removal while noting the following: |
Note t
| The screw thread on the new lambda probe is coated with a special paste. The paste must not get into the slots on the probe body. |
t
| When reusing the lambda probe, only grease the thread with hot bolt paste -G 052 112 A3-; the paste must not get into the slots on the sender body Locking fluid for hot working bolts → ETKA (Electronic parts catalogue) |
t
| When assembling, the Lambda sender line must be fixed in its original position to avoid contact with the exhaust pipe. |
t
| Tightening torques: 55 Nm |
|
|
|