Leon Mk1
Assembly overview |
1 - | Purge tube |
q | Check for secure seating |
2 - | Pressure retention valve with connecting hose |
q | Check for secure seating |
q | Coming from fuel tank gravitational valve |
3 - | Venting connection |
q | Visible from below |
4 - | 10 Nm |
5 - | Throttle control unit -J338- |
6 - | Solenoid valve 1 for active carbon filter -N80- |
q | Valve closed with ignition switched off |
q | Valve is activated (pulsed) by engine control unit when engine is warm |
7 - | Connector |
8 - | Active carbon filter |
q | Fitting location: In wheel housing, rear right |
q | Remove right rear wheel housing |
q | Remove the pressure retention valve -2- and the vent pipe -1-, press safety ring for this purpose. |
q | Separate the bolt -4-. |