seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Conversion table by applicability > < Components of exhaust system

Leon Mk1

Ignition coil with output stage: Removing and fitting
Ignition coil with output stage: Removing and fitting
Special tools and workshop equipment required
   
t  Assembly tool -T10118-
  W00-1148
t  Extractor -T10094 A-, see note → Anchor
  Note
The housing for the ignition coils and final power stages have been modified. For this reason, these coils may only be removed and fitted using the extractor -T10094 A-. The extractor -T10094 A- may remain in use if modified as described below.
  W00-10526
–  Lower the marked area -2- using appropiate workshop means in order to set the -B- 18 mm nominal value.
–  Add letter A -1- onto the tool designation.
Removing
  N28-10068
–  Fit the extractor -T10094A-on the ignition coils with output stage -arrow- as in the illustration.
–  Lightly extract the ignition coils with output stage.
–  Connect the assembly tool -T10118- as shown.
–  Carefully open the connector lock and remove the connector.
Fitting
–  Fit the extractor -T10094A- on the ignition coils with output stage.
–  Push the connector over the ignition coil with output stage until it snaps into place.
  N28-0284
–  Insert the ignition coil with output stage in the cylinder head in the -direction of the arrow-.
  N28-0285

Conversion table by applicability > < Components of exhaust system