Leon Mk1
Catalytic converters and accessories - assembly overview |
1 - | Warm air collector plate |
2 - | 10 Nm |
3 - | Lambda probe -G39-, 50 Nm |
q | Only grease the thread with “G 052 112 A3”. The “G 052 112 A3” must not reach the probe body grooves |
q | Remove and assemble using the ring wrench set for lambda probes -3337- |
q | In case of leakage, cut out and replace sealing ring |
4 - | Exhaust manifold with primary catalyst |
q | Protect from damage by knocks and impact |
5 - | Gasket |
q | Replace |
6 - | 25 Nm |
q | Replace |
7 - | Connector |
q | Four-pin |
8 - | Connector |
q | Four-pin |
9 - | Lambda after catalytic converter -G130-, 55 Nm |
q | Apply high-temperature lubricant -G 052 112 A3- to thread only. The high-temperature lubricant -G 052 112 A3- must not get into the slots on the probe body. |
q | The connector is located under the right hand side vehicle floor housing. |
10 - | Double clamp, 25 Nm |
q | Align exhaust system when it is cold so it is free of stress before tightening clamp |
q | Installation position → Fig. |
q | Tighten bolted connections evenly. |
11 - | Front tube bridge |
12 - | 23 Nm |
13 - | Principal catalytic converter with exhaust pipe |
q | Mit Kupplungsstück |
q | Do not bend flexible connection more than 10°. It may be damaged |
14 - | Suspension element |
q | Replace when damaged. |
15 - | 20 Nm |
16 - | 40 Nm |
q | Replace |
17 - | Holder |
18 - | Cable guide |
|