SEAT Workshop Service and Repair Manuals

Adjusting assembly mounting   Note If only the assembly mounting at the engine end is to be adjusted, it is not necessary to remove the air filter housing, battery or battery tray. Adjustment: Proceed as follows: –  Remove the engine cover → Chapter –  Remove the air filter housing → Chapter.   Caution When disconnecting the battery there is a risk of serious damage to electronic components: Observe the correct procedure for disconnecting the battery.

–  With ignition switched off, disconnect battery earth cable -arrow-. –  Remove battery → Electrical system; Rep. gr.27

–  Remove bolts -arrows- and take out battery mounting -1- . –  Support engine with gearbox in installation position → Chapter but do not raise.

–  Renew assembly mounting bolts -arrows- on engine side one after the other (if not already carried out during engine installation) and screw in hand-tight.

–  Renew assembly mounting bolts -arrows- on gearbox side one after the other (if not already carried out during engine installation) and screw in hand-tight. –  Slacken bolts on left and right-hand support arms by about two turns each. –  Adjust assembly mounting and screw in securing bolts hand-tight.

Assembly mounting on engine side: l  There must be a distance -a- of at least 10 mm between the engine support foot and the right-hand side longitudinal member. l  The moulded edge on the engine support -2- must be parallel to the support arm -1-.

Assembly mounting on gearbox side: l  Ensure that edges of support arm (on gearbox side) -1- and gearbox mounting -2- are parallel. l  Dimension -x- is the same for both sides of the mount. –  Tighten bolts for assembly mounting to required specified torque → Chapter. Further assembly in reverse order of removal.