SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Coolant pump, thermostat, coolant pipes >
< Cooling system
Leon Mk1
Power unit
4 cylinder Injection engine (2.0l, 4V Direct injection, turbocharger and chain control)
Engine cooling
Radiator and radiator fans
Removing and installing radiator
Removing and installing radiator
Removing:
–
Remove the sound insulation
→ Bodywork, exterior installation work; Rep. gr.50
–
Place drip tray for workshop cranes -VAS 6208- beneath engine.
–
Disconnect coolant hose
-1-
from radiator (right side) and drain off coolant.
–
Remove the air filter housing
→ Chapter
.
–
Pull off coolant hose
-arrow-
from radiator (left) and allow coolant to drain.
–
Remove radiator cowl
→ Chapter
.
–
Unscrew air duct on lock carrier
-arrows-
.
–
Unscrew bolts
-1 and 2-
.
–
Unscrew securing bolt
-arrow-
for coolant pipes.
Note
Pull radiator away from coolant pipe bracket when unscrewing securing bolt.
–
Remove radiator upwards.
Installing:
–
Bring radiator into installation position and start securing bolt for coolant pipe bracket first.
–
Tighten bolts
-1 and 2-
.
–
Tighten securing bolt for coolant pipe bracket.
Further assembly in reverse order of removal.
l
Tightening torque, radiator to intercooler: 5 Nm
l
If the radiator was renewed, new coolant should be used.
Power unit
4 cylinder Injection engine (2.0l, 4V Direct injection, turbocharger and chain control)
Engine cooling
Radiator and radiator fans
Coolant pump, thermostat, coolant pipes >
< Cooling system