SEAT Workshop Service and Repair Manuals

Removing and installing vibration damper Special tools and workshop equipment required

t  Locking pin -T10060 A-

t  Counterhold tool -T10355- Removing: Proceed as follows: –  Remove noise insulation → General body repairs, exterior; Rep. gr.50 –  Remove right wheel housing liner → Bodywork, exterior fitting work; Rep. gr.66.

Vehicles with auxiliary heater: –  Slacken clip -1- and remove bolt -2-. –  Detach exhaust silencer for auxiliary heater.

All: –  Remove bolts -arrows-. –  Remove air pipe (lift clips -item 1 and 2-). –  Remove poly V-belt → Chapter.

–  Turn vibration damper to „TDC“ position -arrow- using counterhold tool -T10355-. l  Notch on vibration damper must align with arrow marking on cover for timing chains (bottom). –  Remove bolt for vibration damper using counterhold tool -T10355-.   Caution Risk of damage to the engine! To avoid disturbing valve timing, do not turn crankshaft out of „TDC“ position when vibration damper is removed.

Installing: l  Tightening torque → Chapter Installation is carried out in the reverse order; noting the following in the process:   Note t  Renew bolt for vibration damper. t  Fit new O-ring -1-. –  Lubricate sealing lip of oil seal with engine oil. –  Fit vibration damper (pay attention to shape of tooth -arrow-).