SEAT Workshop Service and Repair Manuals > Leon Mk1 > Power unit | 4 cylinder Injection engine (Autogas) | Enginecrankshaft group, pistons

Removing and installing Poly-V belt

Check the tool and equipment equivalence table according to the applicability between Seat / VW / Audi / Skoda → Chapter

Special tools and workshop equipment required

t	Pin -T10060A-

Removal:

–	Remove the sound-proofing → Body, exterior assembly work; Rep. gr.50.

–	Mark direction of rotation of poly V-belt.

–	Swing tensioning element in direction of arrow to relieve tension on poly V-belt.

–	Lock the tensioning device with the pin -T10060 A-.

–	Detach poly V-belt.

Installing

Fit the poly V-belt in the reverse order, paying attention to the following:

t	When fitting the Poly-V belt, ensure that it is fitted with the correct direction of rotation and that it is correctly seated on the pulleys.

t	For those vehicles not fitted with air conditioning, fit the Poly-V belt lastly on the alternator.

t	For vehicles with air conditioning, put Poly-V belt over air conditioning compressor last.

After completing the work, always start the engine and check that the belt rotates correctly.

Belt routing without air conditioning compressor

Belt routing with air conditioning

SEAT Workshop Service and Repair Manuals