–
| Unbolt the Lambda probe -G39--1- or the lambda probe after the catalytic converter -G130--2-using the Set of wrenches -3337-. |
When fitting, note the following: |
Note t
| The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body |
t
| If a lambda probe is reused, apply paste to the bolts when warm; the paste must not get into the slots on the probe body. Locking fluid for hot working bolts → ETKA (Electronic parts catalogue) |
t
| When assembling, the lambda probe cable must be fixed in its original position to avoid contact with the exhaust pipe. |
t
| Tightening torque: 52 Nm |
|
|
|