SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Enginecrankshaft group, pistons >
< Engine brackets: adjustment
Leon Mk1
Power unit
4 cylinder TDI engine (1.9l engine, mechanics)
Engine assy,cylinder block,crankcase
Engine: Removing and installing.
Engine and gearbox: Separate
Engine and gearbox: Separate
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
counterhold -T20186-, see equivalent
→ Anchor
t
Workshop crane
Requirements:
l
Engine/gearbox assembly removed and fixed on engine bracket -T20205-.
Operation process
–
Unscrew bolt
-1-
with gearbox fitted.
–
Pull the cover plate
-2-
off upwards.
Note
This is shown in the figure with the gearbox removed.
Vehicles with four wheel drive:
–
Extract bolts
-1... 3-
and remove the support for the angular gear.
All vehicles (continued):
–
Unscrew the bolts
-1 … 8-
on the flange between the engine and the gearbox.
–
Take out starter motor.
Note
The gearbox is shown in illustration with engine removed.
–
Place the support tool -T20186- on the gearbox, as shown in the illustration.
–
Carefully separate the gearbox from the engine, using the workshop crane.
Power unit
4 cylinder TDI engine (1.9l engine, mechanics)
Engine assy,cylinder block,crankcase
Engine: Removing and installing.
Enginecrankshaft group, pistons >
< Engine brackets: adjustment