Removing and installing cylinder head |
Note t
| When installing an exchange cylinder head with fitted camshaft, the contact surfaces between roller rocker fingers and the cam contact surfaces must be oiled before installing the head. |
t
| The plastic protectors fitted to protect the open valves should not be removed until the cylinder head is ready to be fitted. |
t
| When fitting a new cylinder head or cylinder head gasket, drain off all the old coolant and re-fill with new coolant. |
t
| Reworking diesel cylinder heads is not permissible. |
t
| Renew cylinder head bolts. |
t
| When fitting, replace the self-locking nuts and bolts. |
t
| Renew bolts which have a specified tightening angle, as well as seals and gaskets. |
t
| Carry out an engine oil change if this is dirty → Booklet 1. |
|
|
|