Leon Mk1
| Exhaust system: component overview |
| 1 - | Rear tube bridge |
| 2 - | Middle silencer |
| q | In case of repairs, replace the factory fitted end silencer as one part |
| q | Cutting point → Chapter |
| q | Fit and align exhaust system free of stress → Chapter. |
| 3 - | Mounting |
| q | If this is damaged, replace it |
| 4 - | Suspension |
| q | If this is damaged, replace it |
| 5 - | 23 Nm |
| 6 - | Suspension |
| q | If this is damaged, replace it |
| 7 - | Securing clip - 7 Nm |
| 8 - | Seal |
| 9 - | Primary exhaust pipe |
| q | With catalytic converter |
| q | Protect from damage by knocks and impact |
| q | With flexible connection (de-coupling element) |
| q | Do not bend flexible connection more than 10° - otherwise it can be damaged |
| q | Removing and fitting → Chapter |
| q | Fit and align exhaust system free of stress → Chapter. |
| 10 - | Brace |
| 11 - | 40 Nm |
| 12 - | 40 Nm |
| 13 - | Front clamp |
| q | Align exhaust system so it is free of stress before tightening clamp → Chapter |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 14 - | 25 Nm |
| 15 - | Front tube bridge |
| 16 - | 23 Nm |
| 17 - | 23 Nm |
| 18 - | Mounting |
| q | If this is damaged, replace it |
| 19 - | Rear clamp |
| q | For separate replacement of centre and rear silencers |
| q | Installation position → Fig. |
| q | Tighten bolted connections evenly. |
| 20 - | 25 Nm |
| 21 - | Mounting |
| q | If this is damaged, replace it |
| 22 - | Secondary silencer |
| q | In case of repairs, replace the factory fitted middle silencer as one part |
| q | Cutting point → Chapter |
| q | Fit and align exhaust system free of stress → Chapter. |
| 23 - | Suspension |
| q | If this is damaged, replace it |
| 24 - | 23 Nm |
| 25 - | 23 Nm |
|
|
|
|
