Engine control unit: replace |
Special tools and workshop equipment required |
t
| Fault reader -V.A.G 1551- with cable -V.A.G 1551/3B- |
–
| In the first place, print the identification of the control unit and, using this, the code of the previous control unit, proceeding as follows: |
–
| Connect the -V.A.G 1551- (-V.A.G. 1552-) and, using the corresponding “direction code” 01, select the control unit for the engine electronics. (Fault reader: Turn on and select the control unit for engine electronics → Chapter). |
|
|
|