Leon Mk1
Intake manifold: dismantling and assembling |
1 - | Throttle valve control part -J338-* |
q | Components of throttle valve control part -J338-: Throttle valve positioner -V60-*/**, throttle valve potentiometer -G88- *, throttle valve potentiometer -G69-* and idling switch -F60-* |
q | Checking → Chapter |
q | If replaced match engine control unit → Chapter |
q | Gold terminal contacts |
2 - | 10 Nm |
3 - | Gasket |
q | Note fitting position |
q | Renew |
4 - | Intake connecting flange |
5 - | Sealing ring |
q | Renew if damaged |
6 - | 20 Nm |
7 - | Sealing ring |
q | Renew |
8 - | Guide plate |
q | Note fitting position |
q | Renew if damaged |
9 - | O-ring |
q | Renew if damaged |
10 - | 3 Nm |
11 - | Intake manifold pressure sender -G71-* with intake air temperature sender -G42-* |
q | Intake manifold pressure sender Check → Chapter |
q | Checking intake air temperature sender → Chapter |
q | Intake air temperature sender resistance values between contacts 1 and 2 → Fig. |
q | Gold terminal contacts |
12 - | Intake manifold |
q | Removing and installing → Chapter, Injection system components: removal and installation |
13 - | Vacuum hose |
q | From fuel pressure regulator → Item |