Leon Mk1
Part III |
1 - | Support |
q | For warm air collector plate |
2 - | 25 Nm |
3 - | 20 Nm |
4 - | Warm air collector plate |
5 - | Flange |
q | Check for scratches and deformation |
6 - | 13 Nm |
q | Immobilise the bolt under the throttle valve lever using a washer |
7 - | Support |
q | For the intake manifold |
8 - | CO measurement tube sealing cap |
9 - | CO measurement tube |
10 - | CO tube attachment connection, 13 Nm |
11 - | To liquid coolant tube |
12 - | Depression inlet |
q | To the brake servo |
13 - | O-ring |
q | In case of deterioration, replace |
14 - | Gasket |
q | Replacement |
15 - | Inlet manifold pre-heater -N51- |
q | Verification prerequisites: engine cold |
q | Resistance between the connector and the earth (-): 0.25…0.50 Ω |
q | Verify the activation → Chapter, Actuator diagnostics |
16 - | 10 Nm |
17 - | O- ring |
18 - | Intake manifold |