While testing or fitting, the other control units may also detect faults, such as unplugged connectors. Thus, once work is finished, consult and clear all control unit fault memories, as follows: |
–
| Press 0 twice to enter the address code “Automatic test cycle” and press Q to confirm the entry. The -V.A.G 1551- will emit all known address codes in succession. |
If the control unit responds with its identification, the display will show the number of faults found or “no faults found”. |
Stored faults are displayed and printed out in succession. Then the -V.A.G 1551- sends the next address code. |
|
|
|