seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABS Mark 60 -ABS/EDS/ASR/ESP/RKA+/EBA/DSR - HHC (from week 22.08) - XDS 12 - NBA 3 > < ABS Mark 70 -ABS/ASR/EBV/RKA- (after week 22.08)
ABS Mark 60 -ABS/EDS/ASR/ESP- (until week 22.08)
   
ABS Mark 60 -ABS/EDS/ASR/ESP- (until week 22.08)
1 - ABS control unit -J104-
q   Assembly location: in the hydraulic control unit, in the engine compartment, to the right
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
q   Do not separate connector before successfully completing self-diagnosis. Switch ignition off before separating connector.
q   Removing and installing → Chapter
2 - Hydraulic units for the ABS. -N55-
q   Fitting location: in engine compartment (right-side)
The hydraulic unit consists of the following components:
q   ABS hydraulic pump -V64-
q   Brake pressure sender 1 -G201-
q   Can be checked using „Guided fault finding“ of the vehicle diagnostic, testing and information system -VAS 505X-.
q   Valve block (contains inlet and outlet valves).
q   The ABS hydraulic pump -V64- must not be separated from the valve block
q   Removing and installing → Chapter
3 - Brake system indicator -K118-
q   Location: in dash panel insert.
q   Function: → Chapter
4 - ABS warning lamp -K47-
q   Location: in dash panel insert.
q   Function: → Chapter
5 - Stability Program Indicator, ASR/ESP -K155-
q   Only in vehicles fitted with ABS/EDS/ASR/ESP
q   Location: in dash panel insert.
q   Function: → Chapter
6 - Brake pad warning lamp -K32-
q   Location: in dash panel insert.
q   Function: → Chapter
7 - Brake light switch -F- and brake pedal switch -F47-
q   In vehicles prior to week 45/05
q   Location: on brake pedal
q   Removing and installing → Chapter
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
8 -  Brake pedal position sender -G100-
q   In vehicles after week 45/05
q   Location: on brake pump
q   Removing and installing → Chapter
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
9 - TCS and ESP button -E256-
q   Only in vehicles fitted with ABS/EDS/ASR/ESP
q   Location: in centre console.
10 - ESP sensor unit -G419-
q   Only in vehicles fitted with ABS/EDS/ASR/ESP
q   Location: behind passenger seat
q   Combination of Transversal acceleration sender -G200 -, turn magnitude sensor -G202- and longitudinal acceleration sender -G251-
q   Integrated into one casing
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
q   Removing and installing → Chapter
11 - Steering angle sender -G85-
q   Installation location: on the steering column between the steering wheel and the steering wheel lever.
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
q   Removing and installing → Chapter
12 - Diagnostic connection
q   Installation area: cover in footwell on the driver side
13 - Revolution sensor for the front right hand wheel -G45-/Revolution sensor for the front left hand wheel -G47-
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
q   Removing and installing → Chapter
14 - Wheel bearing housing
15 - Wheel hub with wheel bearing
q   The ABS sensor ring is fitted in the wheel bearing
16 - Rear right speed sensor -G44 -/rear left speed sensor -G46-
q   Can be checked in „Guided fault finding“, using vehicle diagnostic, testing and information system -VAS 505X-.
q   Removing and installing → Chapter
17 - Wheel bearing housing
Figure for front traction
18 - Wheel hub with wheel bearing
q   The ABS sensor ring is fitted in the wheel bearing

   

ABS Mark 60 -ABS/EDS/ASR/ESP/RKA+/EBA/DSR - HHC (from week 22.08) - XDS 12 - NBA 3 > < ABS Mark 70 -ABS/ASR/EBV/RKA- (after week 22.08)