seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing > < Connecting brake pipes from tandem brake master cylinder to hydraulic unit

Leon Mk1

Removing and installing control unit and hydraulic unit
   
Removing and installing control unit and hydraulic unit

Special tools and workshop equipment required
t  Torque wrench -V.A.G 1331-
t  Torque wrench -V.A.G 1410-
t  Brake pedal depressor -V.A.G 1869/2-
   
Sealing plugs repair kit, Part No. 1H0 698 311 A
The transport protection for the valve contact pin must always be placed on the hydraulic unit after the control unit has been disconnected from the hydraulic unit.
No guarantee will be recognised for hydraulic units without transport protection.
1 - Transport protection for valve contact pin (foam)
2 - Sealing plugs M 10
3 - Sealing plugs M 12
Location:
The control unit is bolted to the hydraulic unit and is located on left in the engine compartment.
  Caution
Do not bend the brake pipes in the area of the hydraulic unit!
  N45-0039

Removing > < Connecting brake pipes from tandem brake master cylinder to hydraulic unit