When connecting the ignition and/or starting the engine the system indicators -1- ABS -K47-, indicator -2- brake system -K118-, and indicator -3- antiskid program -K155- will light up for two seconds. Test sequence. |
If after the test sequence is completed the indicators -K47-, -K155- do not turn off, the fault causes can be: |
t
| The voltage supply is less than 10 V |
t
| There is a problem in the TCS system, or it has been disconnected through the button -E256- |
t
| There is a problem in the CAN-BUS line |
t
| There is a problem in the ABS system |
t
| The engine unit is coded incorrectly |
t
| The ABS/EDL brake unit is coded incorrectly |
t
| Checking brake fluid level |
Caution If after the test sequence is carried out, the ABS -K47- control indicator and -K118- brake system indicator remain lit, the rear wheels may be braking ahead of time. |
|
Prior conditions to ensure good functioning of the ABS/EDL/TCS brake system. |
Depending on the motorisation test of the engine unit code. |
–
| Diesel engines check if the engine unit code is correct → Rep. Gr.23 |
–
| Petrol engines check if the engine unit code is correct → Rep. Gr.24 |
|
|
|