seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Faults displayed by warning lamps K14 , K47 and K118 > < Removing and installing parts of ESP system

Leon Mk1

Faults displayed by warning lamps K14, K47 and K118
Faults displayed by warning lamps -K14-, -K47- and -K118-
Warning lamp -K47-
   
t  If the ABS warning lamp -K47--1- does not go out after switching on the ignition and completion of the test sequence, the fault may be:
a - voltage supply is below 10 Volt.
b - there is a fault in the ABS.
The anti-locking brake system remains switched off with an ABS fault -b-, but the conventional brake system remains fully operational.
c - since the last time the vehicle was started there was a temporary speed sensor fault.
In the case of sensor fault -c- the ABS warning lamp will extinguish automatically after restarting the engine and 20 km/h (approx. 13 mph) is exceeded.
d - there is an open circuit in the connection from the dash panel insert to control unit -J104- → Current flow diagrams, Electrical fault finding and Fitting locations
e - dash panel insert is defective.
Warning lamps -K47- and -K118-
  E01-0032
t  If the ABS warning lamp -K47--1-, goes out, the brake system warning lamp -K118--2- remains on and 3 audible warning are heard, the fault may be:
a - the brake fluid level is too low.
b - a fault in the activation of the brake system warning lamp -K118- → Current flow diagrams, Electrical fault finding and Fitting locations
t  If the ABS warning lamp -K47--1- and the brake system warning lamp -K118--2- both come on, the ABS system is defective and the EBD (electronic brake pressure distributor) is not functioning. A change in braking behaviour must be reckoned with.
  Caution
When the ABS warning lamp -K47- and the brake system warning lamp -K118- have lit up it is possible that the rear wheels will lock up earlier when braking.
Warning lamp -K14-
  E01-0032
t  If the handbrake warning lamp -K14--3- does not go out after switching on the ignition, the fault may be:
a - the handbrake is pulled on.
b -  the switch for the warning lamp -K14- is defective or incorrectly set.
c - there is a wire routing fault. → Current flow diagrams, Electrical fault finding and Fitting locations
Vehicles with ABS/EDL
Problem: “EDL is not functioning on vehicle”.
For this problem a possible fault cause may be the brake light switch is incorrectly adjusted → Chapter.
A further possibility is that the brake light switch is not functioning → VAS 5051.
  E01-0032

Faults displayed by warning lamps K14 , K47 and K118 > < Removing and installing parts of ESP system