Leon Mk1
| II - Rear brake, removal and installing (vehicles with drum brakes from 09.00) |
| 1 - | Star-head screw |
| q | 4 Nm |
| 2 - | Brake drum |
| q | Before removing retract the brake linings throgh the wheel bolt threaded holes → Fig.,clean carefully, check for damage and wear and check dimensions and state of braking surface |
| Vehicles without ABS: |
| q | Brake drum: Ø 180.00 mm |
| q | Wear limit: 181.50 mm |
| q | In case of wear replace the discs of the same shaft |
| Vehicles with ABS: |
| q | Brake drum: Ø 200.00 mm |
| q | Wear limit: 201.50 mm |
| q | In case of wear replace the discs of the same shaft |
| 3 - | Protective cap |
| q | Removing and refitting: → Running gear, axles, steering; Rep. Gr.42 |
| q | Replace after removing |
| For perfect sealing always use a new dust sleeve cover. |
| This is the only way to ensure a long and trouble-free life. |
| 4 - | Twelve-sided nut |
| q | 175 Nm |
| q | Replace after removing |
| 5 - | Wheel bearing /wheel hub |
| q | With wheel hub and rotor for revolution sensor |
| q | Revolution sensor rotor → Chapter |
| q | Removing and installing: → Running gear, axles, steering; Rep. Gr.42 |
| The bearing and wheel hub are together in one casing. |
| These wheel bearings/Wheel hubs do not need inspection and have no play. They cannot be adjusted or repaired! |
| 6 - | Hexagon bolt |
| q | With plate spring |
| q | 60 Nm |
| 7 - | Brake plate with brake shoes |
| q | Dismantling and assembling → Chapter |
| 8 - | Axle stub |
| q | Straightening is forbidden! |
| q | The thread must not be repaired! |
| 9 - | Revolution sensor rear left/righ -G44-/-G46- |
| q | Checked by self-diagnosis: → VAS 5051 |
| q | Before fitting the sensor, clean the interior seating surface and coat with G 000 650 lubricating paste |
| q | When fitting revolution sensors make sure that the cables are not twisted when inserted into the wheel housing |
| q | The rotors and front revolution sensors on both sides are identical |
| q | Removing and installing → Chapter |
| q | Revolution sensor cable: removing and installing → Chapter |
| 10 - | Allen head bolt |
| q | 8 Nm |
