Leon Mk1
| Rear brake: repairing |
Note!| t | Release hand brake. |
| t | Press the pedal with the vehicle stationary. |
| 1 - | Spring plate |
| q | To remove press it against the spring and turn 90° |
| 2 - | Compression spring |
| 3 - | Brake shoe with lever for hand brake |
| q | Removing and installing → Chapter |
| q | Adjust hand brake → Chapter |
| q | Thickness: checking: → Booklet |
| q | Correspondance: → Parts Catalogue |
| Vehicles without ABS: |
| q | Brake pad thickness: 30.00 mm |
| q | Brake pad thickness: 5.00 mm |
| q | Wear limit: 2.50 mm |
| q | In case of wear replace both discs on the same axle |
| Vehicles with ABS: |
| q | Brake pad thickness: 40.00 mm |
| q | Brake pad thickness: 5.00 mm |
| q | Wear limit: 2.50 mm |
| q | In case of wear replace the discs of the same shaft |
| The linings can also be supplied without brake shoes |
| 4 - | Upper return spring |
| q | Release with spring pliers |
| 5 - | Lower return spring |
| q | Grease friction zones with lubricating paste, part no. G 000 650 |
| 6 - | Draft spring |
| 7 - | Brake shoe |
| q | Removing and installing → Chapter |
| q | Thickness: checking: → Booklet |
| q | Correspondance: → Parts Catalogue |
| Vehicles without ABS: |
| q | Brake pad thickness: 30.00 mm |
| q | Brake pad thickness: 5.00 mm |
| q | Wear limit: 2.50 mm |
| q | In case of wear replace both discs on the same axle |
| Vehicles with ABS: |
| q | Brake pad thickness: 40.00 mm |
| q | Brake pad thickness: 5.00 mm |
| q | Wear limit: 2.50 mm |
| q | In case of wear replace both discs on the same axle |
| The linings can also be supplied without brake shoes. |
| 8 - | Cap |
| q | Remove to check lining thickness |
| 9 - | Pin |
| 10 - | Brake back plate |
| 11 - | Allen head bolt |
| q | 8 Nm |
| 12 - | Wheel brake cylinder |
| q | Checking → Fig. |
| q | Correspondance: → Parts Catalogue |
| Vehicles without ABS: |
| q | Wheel brake cylinder: Ø 15.87 mm |
| Vehicles with ABS: |
| q | Wheel brake cylinder: Ø 17.46 mm |
| 13 - | Wedge |
| q | To remove and install the brake drum, press upwards and through one of the threaded openings for the wheel bolts → Fig. |
| 14 - | Push rod |
| q | Grease friction zones with lubricating paste, part no. G 000 650 |
| 15 - | Contact spring |
| q | Release with spring pliers |
|
|
