SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
II - Rear brake, removal and installing (vehicles with drum brakes from 09.00) >
< I - Rear brake, removal and fitting (vehicles with drum brakes up to 08.00)
Leon Mk1
Running gear
Brake systems
Brake, brake mechanics
Rear brake: repairing (vehicles with drum brakes)
Revolution sensor rotor: removal and fitting (vehicles with drum brakes up to 08.00)
Revolution sensor rotor: removal and fitting (vehicles with drum brakes up to 08.00)
Revolution sensor rotor: removal and fitting (vehicles with drum brakes up to 08.00)
Special tools and workshop equipment required
t
Guide sleeve of the fitting seal -U-40014/B- (left)
t
Torque wrenches -SAT 8010-
Removing
–
Raise the vehicle.
–
Unbolt wheel.
–
Remove brake drum:Before removing, retract the brake linings through the wheel bolt threaded holes
→ Fig.
–
Remove the revolution sensor rotor from the brake drum with two screwdrivers.
Installation
–
Fit the revolution sensor rotor with the guide sleeve of the fitting sleeve -U-40014/B-.
–
Fit the brake drum and adjust the wheel bearing play
→ Fig.
–
Press the brake pedal with the vehicle stationary and the rear brake will be adjusted.
Running gear
Brake systems
Brake, brake mechanics
Rear brake: repairing (vehicles with drum brakes)
Revolution sensor rotor: removal and fitting (vehicles with drum brakes up to 08.00)
II - Rear brake, removal and installing (vehicles with drum brakes from 09.00) >
< I - Rear brake, removal and fitting (vehicles with drum brakes up to 08.00)