Leon Mk1
General overview: rear axle body |
1 - | Support block for rear axle |
2 - | 10 Nm |
3 - | ABS revolution sensor |
4 - | Shock absorber |
q | Installation position → Fig. |
5 - | Self locking nut |
q | When tightening note the fitting angle between the rear axle and the shock absorber → Fig. |
q | Replace |
6 - | Axle stub |
q | Straightening repairs are not permitted. |
7 - | Splash plate |
8 - | Allen bolt |
q | 65 Nm |
9 - | Brake caliper |
q | Repairs → Brake system; Rep. Gr.46 |
10 - | Brake disc |
11 - | 4 Nm |
12 - | Dustguard cover |
q | Always replace |
q | Remove → Fig. and re-insert. → Fig. |
q | So that the seal is perfect, a new dust guard cover should always be used. |
q | Only in this way can the optimal operation and long life of the part be guaranteed. |
13 - | Twelve-sided, self-locking nut |
q | 175 Nm |
q | Replace |
14 - | Wheel hub and bearing assembly |
q | These come together in one housing. |
q | The bearing and the hub do not require inspection. |
15 - | 60 Nm |
q | Replace |
16 - | Brake drum |
17 - | Hand brake cable |
18 - | Brake carrier with brake pads |
19 - | Self locking nut |
q | 65 Nm |
q | Replace |
20 - | Hydraulic bonded rubber bush |
q | Not supplied as a spare part. |
q | Replace the bearing if it is not sealed. |
q | Remove and fit the bonded rubber bearing → Chapter |
21 - | Hand brake cable support |
22 - | Axle body |
q | Keep the contact surface and the screw holes for the axle rod free of paint and dirt. |
23 - | Bolt |
q | Fit from the centre of the vehicle. |
24 - | Cable channel |
q | Only on vehicles equipped with ABS |
25 - | Bolt |
26 - | Metal/rubber bearing |
q | Removal and fitting → Chapter |