seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Steering wheel knuckle and trailing arm - Remove and install|Installation > < Steering wheel knuckle and trailing arm - Remove and install

Leon Mk1

Removal:
Removal:
–  Remove coil springs → Chapter.
–  Release the bolt from the outer side of the half-shaft.
t  Hex bolt → Chapter
t  Twelve-point head bolt with ribbing → Chapter
t  Twelve-point head bolt without ribbing → Chapter
–  Remove wheel.
–  Dismount the brake support and clip and hang on the bodywork using a wire → Rep. gr.46.
  Note
Hang up brake calliper on body.
–  Remove cross-head screw for brake disc and remove brake disc.
–  Install ABS speed sensor in wheel bearing housing.
   
–  Remove bolt -arrow-.
  A42-0421
–  Undo the bolts that join the link bar -1-, the upper transversal swinging arm -2- and the lower transversal swinging arm -3- to the steering knuckle -4-.
–  Unscrew the link rod -arrow- from the steering knuckle.
  A42-0467
–  Hold wheel bearing housing and unscrew bolts -arrows-.
–  Remove coupling rod -1- from trailing arm.
–  Remove the steering knuckle.
  A42-0468

Steering wheel knuckle and trailing arm - Remove and install|Installation > < Steering wheel knuckle and trailing arm - Remove and install