SEAT Workshop Service and Repair Manuals > Leon Mk1 > Running gear | Running gear, axles, steering | Steering | Vane pump, filling reservoir, hydraulic piping

Poly-V belt: tightening

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1410-

t	Insertable ring tool -V.A.G 1410/2-

–	Loosen the hexagonal nut -4- → Note.

–	Loosen the hexagonal bolts -1- → Note.

–	Loosen the locking screw -3- of the tightening bolt -8- at least one turn (⇒ Fig. V48-1064 → Anchor) → Note.

–	Tighten the Poly-V belt by turning the tightening bolt -8-(⇒ Fig. V48-1064 → Anchor) with the torque wrench-A- (-V.A.G 1410- and -V.A.G 1410/2-).

Specification: Used belt, 4Nm; New belt, 7 Nm

–	Tighten the locking screw -3- of the tightening bolt → Chapter.

–	Tighten the hexagonal bolt -1- → Chapter.

–	Tighten the hexagonal bolt -2- and the nut -4- → Chapter.

Note

The nut -4- is only found in vehicles with petrol engines.

¹⁾	If it has not yet been loosened.

SEAT Workshop Service and Repair Manuals