seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
II - Removing and installing wheel bearing, suspension strut, drive shaft > < Modifications to the pendulum support

Leon Mk1

Modified screw for pendulum support
Modified screw for pendulum support
A longer screw was used from 9 March 1998. The hole in the pendulum support was adjusted to fit the longer screw.
   
Dimension -a- of the new screw
  N37-0762
Dimension -a-Specified torque
New:88 mm60 Nm + 90° further
Always renew screw
Previous:78 mm
85 mm		70 Nm

   
The new screw must not be installed in the previous pendulum support!
If the pendulum support is to be renewed, you must pay attention to the length of the screws.
–  Measure the depth of the hole in the pendulum support.
  N37-0443

II - Removing and installing wheel bearing, suspension strut, drive shaft > < Modifications to the pendulum support