seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Description of back of dash panel insert > < Fit a new dash panel insert.

Leon Mk1

Removing and installing dash panel insert
Removing and installing dash panel insert
  Note
Before renewing the dash panel insert, the work procedure „Renewing dash panel insert“ should always be carried out in order that the data stored in the control unit can be read → Chapter.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
  Note
There is no need to remove the steering wheel.
–  Pull steering wheel fully out and lock it in lowest position.
–  Remove upper part of steering column trim → General body repairs, interior; Rep. gr.68.
   
–  Remove securing screws -arrows- of dash panel.
–  Pull dash panel insert backwards straight out of dash panel, taking connected wiring length into consideration.
  N90-10070
–  Swing securing bar -1- in -direction of arrow- and pull off connector -2-.
–  Remove dash panel insert from vehicle.
Installing:
Installation is carried out in reverse order.
  N90-10068

Description of back of dash panel insert > < Fit a new dash panel insert.