seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Towing unit > < Lights and switches in dash panel

Leon Mk1

Removing and installing switches and instruments illumination regulatorE102 and headlight range control regulatorE20
Removing and installing switches and instruments illumination regulator -E102- and headlight range control regulator -E20-
  Note
When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -VAS 3409-, screwdriver) are used to lever out those components using commercially available tape.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Remove light switch → Chapter.
   
–  Unscrew securing bolt -arrow- and unclip switch trim -1- from dash panel.
  N96-10906
–  Release and separate connector -arrow- and remove switch trim -1-.
  N96-10907
–  Release retainers -arrows- on both sides and push the headlight range control regulator -E102- and switches and instruments illumination regulator -E20- forwards out of switch trim.
Installing:
Installation is carried out in reverse order.
  N96-10908

Towing unit > < Lights and switches in dash panel