seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing front left vehicle level sender G78 on front axle > < Renewing front turn signal bulb

Leon Mk1

Removing and installing control unit for gas discharge lamp bulb and headlight range control
Removing and installing control unit for gas discharge lamp bulb and headlight range control
  Caution
Warning high voltage!
Before working on headlights with gas discharge bulbs, always switch off the headlights and remove the ignition key.
Then switch dipped beam on and off again. This will eliminate any possible residual voltage.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove headlight → Chapter.
   
–  Remove the 3 securing bolts -arrows- for control unit.
  N94-0507
–  Remove control unit.
Installing:
  Warning
If a headlight with automatic range control is removed, the basic setting of the headlight must always be performed when reinstalling → Chapter.
Install in reverse order of removal.
  N94-0465

Removing and installing front left vehicle level sender G78 on front axle > < Renewing front turn signal bulb