seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Multi-function unit (electronic central electrics) 09.97?? > < Removing and installing E-box on left side of engine compartment (engine compartment E-box)
Fuse holder and beam in engine compartment, with battery luggage compartment: remove and install
Fuse holder and beam in engine compartment, with battery luggage compartment: remove and install
The fuse box is located in the engine compartment in front of the air filter.
Removing
–  Switch off ignition and all electrical consumers.
–  Disconnect the negative cable of the battery → Chapter.
   
–  Loosen the retaining tabs -arrows- and remove the cover -1- upwards.
–  Loosen the retaining tabs and remove the cover of the fuse box -2- upwards.
  E97-10400
–  Remove the fuse cover -1- upwards.
–  Remove bolt-2-.
–  Remove bolt-3-.
–  Unscrew the nuts -5- and remove the fuse plate -4-.
Remove the fuse holder
–  Remove the air filter → Air filter: remove and install; Rep. gr.23
  E97-10401
–  Unplug the connector -1-.
–  Unscrew the nuts -2, 3 and 4- for securing the lines.
  Note
The nut -2- secures the line from the positive terminal of the battery in the luggage compartment..
–  Remove the relay -6- and the plug connector from the bracket.
–  Unscrew nuts -5-.
–  Unscrew bolt -7-.
Installing
Installation is carried out in the reverse order, noting the following:
–  Tighten the fastening bolts or nuts to the torques shown → Chapter.
  E97-10402

Multi-function unit (electronic central electrics) 09.97?? > < Removing and installing E-box on left side of engine compartment (engine compartment E-box)