| –
| Open the bonnet and support it. |
| –
| Position a small screwdriver beneath spring clip -2-. |
| –
| Raise spring clip -2- until spring clip can be slid over ball socket. |
| –
| Pull gas-filled strut -3- off ball-head pin mounting -1-. |
| After removing gas-filled strut -3-, slide spring clip -2- back immediately. |
WARNING | Proceed with care if gas-filled strut is reused. Spring clip must not be levered completely out of ball socket, as it will otherwise be damaged. Gas-filled strut springs out of mounting and causes damage or injury to operator. |
|
| –
| Releasing gas from gas-filled strut -1- → Chapter |
|
|
|
