SEAT Workshop Service and Repair Manuals

Exhaust gas temperature sender 3 -G495-: Removing and installing. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Wrench kit 17 mm -T10395-, see equivalent → Anchor

t  Torque wrench -VAG 1331-, see equivalent → Anchor. t  Removing → Anchor t  Fitting → Anchor

Removing –  Detach the connector -2- of the exhaust gas temperature sender 3 -G495-.

–  Remove sender 3 for exhaust gas temperature sender -G495--item 1- with 17 mm wrench -T10395/6-.   Note Disregard -item 2, 3-. Fitting l  Specified torque: 45 Nm. Installation is carried out in the reverse order; note the following:   Note t  Apply hot bolt paste to the thread of the temperature sender → Spare parts catalogue. t  Fit cable ties in the original positions when installing.

Location of the exhaust gas temperature sender 3 -G495--Pos. 1-: l  Angled end to left-hand side of vehicle. l  Angle -α- with regard to marking -arrow- = approx. 17°.   WARNING The torque wrench -VAG 1331- must be set to 29 Nm in this case. The correct tightening torque of 45 Nm is achieved by using the extension of the torque wrench -VAG 1331- with the 17 mm wrench -T10395/6-.

–  Screw exhaust temperature sender 3 -G495- in by hand. –  Then tighten to the specified tightening torque using the torque wrench -VAG 1331- and the 17 mm wrench -T10395/6-.