Leon Mk2
|
1 - | Rear brake calliper |
q | removing and fitting → Chapter |
2 - | Wheel hub with rotor |
q | Tightening torques: → Chassis, axles, steering; Rep. gr.42 |
q | Checking rotor → Anchor |
3 - | Bolt. |
Vehicle must be standing on the ground when tightening |
q | Always replace |
q | Tightening torque: → Running gear, axles, steering; Rep. gr.42 |
4 - | Brake disc |
q | Always replace by axles |
q | Unscrew brake calliper before removal. |
q | Lubricate contact surfaces between brake disc and wheel hub with grease → replacement part catalogue. |
q | Allocation → Chapter |
q | Thickness → Chapter |
5 - | Wheel nut |
Vehicle must be standing on the ground when tightening |
q | Install wheels → chassis, axles, steering; Rep. gr.44 |
6 - | Wheel bearing housing |
q | Tightening torques: → Chassis, axles, steering; Rep. gr.42 |
7 - | Speed sensor |
q | Left and right parts are identical |
q | removing and fitting → Chapter |
q | Before fitting the sensor, clean the inner surface of the hole and apply solid lubricant paste → Parts catalogue. |
q | Press home in wheel bearing housing |
q | Release speed sensor connector and unplug. Unhook cable from speed sensor |
8 - | Bolt. |
q | Tightening torque: 10 Nm |
9 - | Bolt, 75 Nm |
q | Always replace |