seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Brake calliper AP Racing (16??)): Removing and installing.|Installation > < Brake calliper AP Racing (16??)): Removing and installing.

Leon Mk2

Removal:
Removal:
  Note
Mark the brake pads that are going to be re-used before removing them. It is necessary to fit them in the same position. If not, the braking effect will not be uniform.
–  Remove the brake pads → Chapter.
–  Connect the bleeder hose of bleeder bottle -SAT 1175B/1- to bleeder valve on brake caliper and open bleeder valve.
   
–  Fit the block for the brake pedal -VAG 1869/2-.
–  Close bleeder valve and remove bleeder bottle -SAT 1175B/1-.
–  Unscrew the brake pipe from the brake calliper → Item.
–  Unscrew the locating screws of the brake calliper on the wheel bearing housing → Item
–  Remove the brake calliper.
–  Clean the brake callipers, especially the contact surface of the brake pad which absolutely must be free of debris and grease.
  Note
Only alcohol may be used to clean the brake calliper housing.
  A44-0020

Brake calliper AP Racing (16??)): Removing and installing.|Installation > < Brake calliper AP Racing (16??)): Removing and installing.